为您找到"
be on one&
"相关结果约100,000,000个
3. To perform exceptionally well or impressively. The home team is really on tonight, it looks like they'll have an easy victory. A: "Their third baseman just was not on tonight."
For that matter, it can be done with one amplifier--many 4-input Marshalls (and probably bassmans and deluxes as well) can be plugged into one jack, and a short cable can then connect the 'normal channel' and the 'bass' or 'microphone' channel together. It is then possible to further tweak your tone by 'balancing' the normal channel and bass ...
So you should be replacing your ampersands with & when writing a URL in your markup. Note that replacing & with & is only done when writing the URL in HTML, where "&" is a special character (along with "<" and ">"). When writing the same URL in a plain text email message or in the location bar of your browser, you would use "&" and not ...
If you had two stereo amps you would need to decide upon either Horizontal passive bi-amping (one amp dedicated to all bass L/R, and one amp dedicated to all M/T for both L/R), or Vertical passive bi-amp (one amp dedicated to each speaker). However, since you have 5 channel, it's a moot point. Use two channels per speaker, as you said.
BE ON is contained in 3 matches in Merriam-Webster Dictionary. Learn definitions, uses, and phrases with be on.
Usually from the effects send or preamp out on one amp to the effects return or power amp in on the slave amp. Done all the time . Reply. Report. cflat. Oct 13, 2008 631 342 4,571 Deep in the Western Mountains Canada. Aug 8, 2012. Add bookmark #3 Aug 8, 2012; Add bookmark #3
You can also put a stereo delay in loop of master amp, then take the R out of the stereo pedal into the return of the 2nd amp. I love stereo and have gigged stereo for 25+ years, but just running 2 amps with an ABY often really sounds cool and complex, especially if one amp is fatter and warmer and the other is more chimey or grindy.
In simple terms, the practice of bi-amping involves the use of an active crossover network on an audio signal so that the crossover sends high-frequency audio (HF) into one amp and low-frequency audio (LF) into another amp. Both of these amps are connected to different inputs on the speaker. The first amp powers the tweeter in the speaker, while the second amp powers the woofer in the speaker.
I'm really lucky in that each carver pro amp has parallel inputs, so I run thebalanced input to one amp, then chain it to the second amp via the other balanced connectors, and so on and so on. Since everything is a balanced connection, there's no hum, or interference, and the sound quality doesn't change if an amp is on or off in the chain. ...
In HTML, the ampersand character ("&") declares the beginning of an entity reference (a special character). If you want one to appear in text on a web page you should use the encoded named entity "&"—more technical mumbo-jumbo at w3c.org.