为您找到"
do one&
"相关结果约100,000,000个
The ampere (/ ˈ æ m p ɛər / AM-pair, US: / ˈ æ m p ɪər / AM-peer; [1] [2] [3] symbol: A), [4] often shortened to amp, [5] is the unit of electric current in the International System of Units (SI). One ampere is equal to 1 coulomb (C) moving past a point per second. [6] [7] [8] It is named after French mathematician and physicist André-Marie Ampère (1775-1836), considered the father ...
Amps, volts, watts, and ohms are the main units used for measuring electricity. Find out how amps, watts, volts, and ohms relate to electricity. ... (Wh) is a unit of energy that measures the amount of work done or energy consumed when a device uses one watt of power for one hour. It helps quantify total energy consumption over time, as opposed ...
If someone likes small boards (which I very much enjoy), say an overdrive or two, UA amp in a box and something like GFI Specular Tempus at the end of it to cover the reverb/delay needs, putting HX One after your drives and before the amp-in-a-box, supercharges the versatility of a small board and even lets you save space because it has a tuner ...
To understand the amounts involved, a milliampere (mA) is one-thousandth of an ampere (or amp). A standard household circuit that supplies your outlets and switches carries 15 or 20 amps (15,000 or 20,000 mA).
For a parallel connection of two speakers, the resulting impedance is half of the impedance of the amplifier (assuming the speakers have the same impedance). Example: You have the same two speakers, but the amplifier has a 4 ohm output.
Distortion will be higher bridged, and the unbridged A404 amp channels should be more than sufficient for your tweeters, so you might try bridging 3+4 on one amp and using the ch1 rca to run the Lh tweeter, and bridging the 3+4 on the other amp and using the ch2 R rca to run the rh tweeter. Or vice versa.
I'm really lucky in that each carver pro amp has parallel inputs, so I run thebalanced input to one amp, then chain it to the second amp via the other balanced connectors, and so on and so on. Since everything is a balanced connection, there's no hum, or interference, and the sound quality doesn't change if an amp is on or off in the chain.
The one that says "A" or "10A" is designed to measure current up to 10 amps, while the one that says "mA" measures milli-amps, up to about 300 mA. If you're not sure which one to use, select the higher "A" or "10A" setting to be sure you don't overload the meter.
One amp has roughly 624,150,000 electrons passing a point each second. There are a couple of things to understand about amps. First, the number of electrons moving is another way of saying how much charge is moving per second. Many people use the water hose analogy. If you think of current like water running through a hose, the amps tell you ...
One amp powers the left channel or speaker, and the other powers the right channel or speaker. Due to this, they can be wired to a speaker and a sub. Apart from the stereo amps, there are 3-channel, 4-channel, and 5-channel amps that can drive speakers and subs at the same time. Three-channel amps can handle a pair of speakers and a sub ...