为您找到"
id magn
"相关结果约100,000,000个
ID MAGN 1 L-> 0.0 rpm O ** WARNING ** ID DONE. Start-up Guide Standard Application Program 5 5 - ROTATION DIRECTION OF THE MOTOR Check the rotation direction of the motor. • Press ACT to get the status row visible. • Increase the speed reference from zero to a small value
Cause : Motor identification is required. This warning belongs to normal start-up procedure. Drive expects user to select how motor identification should be performed: By Identification Magnetisation or by ID Run.. Start Identification Magnetisation by pressing Start key, or select ID Run and start (see parameter 99.10).
It -> 0.0 rpm ** WARNING ** indicates that the motor parameters have been set, and the drive is ID MAGN REQ ready to start the motor identification (ID magnetization or ID Run). ... (FF35) ID RUN SEL Motor Identification Run is selected, and drive Press Start key to start Identification Run. is ready to start ID Run.
Note: If you select STANDARD ID Run, the brake is opened when the Start command is given from the control panel and the brake remains open until the STANDARD ID Run is completed. If you select ID MAGN, the brake is kept closed during the ID Run sequence. 1 -> 0.0 rpm O ACS800 ** WARNING ** ID MAGN REQ 1 -> 0.0 rpm I *** Information *** Press ...
Page 6 When the motor data has been entered a warning appears. -> 0.0 rpm It indicates that the motor parameters have been set, and the ACS 600 is ready to start the motor identification ** WARNING ** (ID magnetisation or ID Run). ID MAGN REQ Select the motor identification. Page 7: Maximum Speed
ID MAGN REQ 1 L-> 0.0 rpm I *** Information *** Press green button to start ID MAGN ID D . D ²< ID MAGN (ID Magnetisation)³s´`,2; . O;< 2;, G ID Magnetisation D m. S °± . ID Run (STANDARD or REDUCED) m D : - $%0µ rpm ¶w23 . m - · ?$%¸(¹ ! º» g$%r¼23 [½c£_ P. m . ID D PQ¾% R3 ¿ ID ¿
Page 273 Code Description Application/Fault Word Status Bit FF30 ID MAGN REQ FF68 ID N CHANGED FF35 ID RUN FF33 ID RUN SEL FF81 IN CHOKE TEMP 03.18 ALARM WORD 5 bit 4 2212 INV CUR LIM 03.18 ALARM WORD 5 bit 8 3200 INV DISABLED 03.18 ALARM WORD 5... Page 274: Limit Word Inv Current limit at inverter overcurrent trip limit.
ID DONE (FF32) ID MAGN (FF31) ID MAGN REQ (FF30) ID N CHANGED (FF68) ID RUN (FF35) Low-end limit Signal . 10.13. activated in the down direction. Drive has performed motor identification magnetisation and is ready for operation. This warning belongs to normal start-up procedure. Motor identification magnetisation is on.
After going through the Group 99 start-up settings, I get a ***WARNING*** message saying ID MAGN REQ. When I depress the Start button on the Control Panel (in Local mode), it takes me to the Actuals screen and the drive doesn't start. Again, I'm confident this is because the run status is Run Disabled. There is no fault history other than ID ...
Yes, the ID Run was performed as instructed in the manual. In any case, the drive is configured as ID Mag that is each time a start command is given, the drive will magnetise the motor to develop the model. ... When you use the ID Magn, it only builds its model on the first start. It does not redo it on every subsequent start. This does ...