为您找到"
freq1
"相关结果约100,000,000个
Comments FREQ1 entries must be selected with the I/O Options or Subcase Information command FREQUENCY = SID. The units for F1 and DF are cycles per unit time. The frequencies defined by this entry are given by fi = F1 + DF * (i -1) where i = 1 to (NDF + 1). All FREQi entries with the same set identification numbers will be used. Duplicate frequencies will be ignored. fN f N and fN−1 f N − ...
Description:Defines a set of frequencies to be used in the solution of frequency response problems by specification of a starting frequency, frequency increment, and the number of increments desired.
FREQ1 - Defines a starting frequency Fstart, a frequency incitement ∆f, and the number of frequency increments to solve NDF. FREQ2 - Defines a starting frequency Fstart, and ending frequency Fend, and a number of logaritmic intervals NF, to be used in the frequency range.
FREQ1: FREQ1 will give a response plot for a set of frequency in a linear increment with constant difference in the frequency. F1 - Lower Frequency Bound DF - Frequency Increment
Calculates the response of a structure to steady state oscillatory excitation. Typical applications are noise, vibration and harshness (NVH) analysis of vehicles, rotating machinery, transmissions, and powertrain systems. Frequency response analysis is used to compute the response of the structure, which is actually transient, in a static frequency domain. The loading is sinusoidal. A simple ...
1. 什么是频响分析？频响分析，即为频率响应分析(Frequency Response Analysis)。指的是 计算在稳态振动激励作用下结构动力响应的一种方法。在频响分析中，激励载荷是在频域中显式定义的，所有的激励在每一个指定…
FREQ1, FREQ2, FREQ3, . . . , FREQ9 Frequency points for SV vs. FREQ tables. Values must be in ascending order. FREQ1 should be greater than zero. Units are cycles/time.
The chip has two frequency registers (FREQ0 and FREQ1) and two phase registers (PHASE0 and PHASE1). By setting or resetting pins 11 (FSELECT) and 10 (PSELECT) of the control word we select which frequency register and which phase register to combine in order to produce the output waveform.
Comments FREQ1 entries must be selected with the I/O Options or Subcase Information command FREQUENCY = SID. The units for F1 and DF are cycles per unit time. The frequencies defined by this entry are given by fi = F1 + DF * (i -1) where i = 1 to (NDF + 1). All FREQi entries with the same set identification numbers will be used. Duplicate frequencies will be ignored. f N f N and f N −1 f N ...
Hello, when specifying the range limits for Frequency/Random response there are three places tp dp it: in NASTRAN Modal Analysis (EIGRL 1 20. 2000. 0 MASS PARAM), in NASTRAN Dynamic Analysis - Options for Dynamic Analysis (,LFREQ,20. PARAM,HFREQ,2000.) and in NASTRAN Dynamic Analysis - Solution Frequencies (FREQ1 3 20. 10. 198)? The Frequency Table is mandatory, we have then four combinations ...