为您找到"
sent&
"相关结果约100,000,000个
The Effect Send and Return on the back of your amp is a great way to use your pedal effectively and get a great, focused tone. Audio examples are included!
6 Beginner Mistakes with Sends and Return Effects Are you scared to use sends, auxiliary returns, and buses? Don't be: we'll show you what mistakes to avoid and how to use mix bus processing to your advantage.
Is send output return input? You would use the "send" jack to the input on the effects unit and output of the effects unit to the "return" jack. This usually prevents any unwanted noise from placing the effects before the input section on the amp. Hope this helps! Billy, those are the preamp send (output) and preamp return (input) for ...
You send your signal out, process it with other equipment and return it back into the original piece of equipment. Amps with send/return or fx loops will usually allow you to manipulate the signal between the amps preamp (some distortion, EQ, and so on) and the power amp which actually moves the speaker.
From the send jack to your first pedal's input, then from your last pedal's output to the return jack. Once you've made these connections with the pedals you want in the effects loop, you can connect your guitar to the amp's input as normal. You can also have other pedals in that signal chain, just like you would without an effects loop at all.
Here is a complete guide to amp effects loops including exactly what they are, why they are useful and how to use one.
The preamp stage of your amplifier processes the guitar's signal, shaping it and possibly adding gain or distortion. The send jack takes this preamp-processed signal and sends it out to your effects pedals or rack-mounted units. Your effects units process the signal, adding effects like delay, reverb, modulation, or other time-based effects.
When using an amp's send/return loop, it's crucial to set your pedals accordingly. Modulation effects, for example, work best here, as they "modulate" the entire guitar signal and benefit from isolation between the preamp and power amp stages.
After that, I can set the level controls for the send and return jacks, if my amplifier has them. The send control helps determine the strength of the guitar signal sent to the effects, which affects the overall tone. Adjusting the return control will determine how much of the processed effect is added to my guitar's signal.
I'm new to multi-effects so bare with me. I'm checking out the GT series by Boss and had question. If I were to plug the FX send/return into the loop of my amp will this allow me to assign the modulation/delays to amps loop and drives to front of the amp? I'm currently looking at the GT8,10 and 100.